![]() The longer the cut, the more likely it is that something will go wrong when creating the design, and you do not want to waste multiple feet of vinyl! It is recommended to not cut a design more than 24 inches in length. If cutting a roll of media, then it is a good idea to loosen up the roll by creating slack between the roll and the cutter. Once the media is fed and rollers are set, you will need to lock the rollers into place. Both of the rollers must be in the shaded area when cutting either roll or sheet media. It is very important that the rollers not be too close to the edge of the material and that both of them are in a shaded area demarcated on the cutter. The media must then be fed into the cutting area where it will be clamped down so that it can be moved over rollers. If using a roll of media, then you will want to set the media on the back roller with the vinyl rolling over the top towards the cutter. The Roland GS-24 is capable of cutting both sheet and roll media. The first thing you will need to do is power on the cutter by clicking the button in the bottom right hand corner of the machine. ![]() Once the driver is installed and the machine is plugged into a computer, you are ready to begin cutting.
0 Comments
Leave a Reply. |